Printer Error 49 Fix - How To Repair The 49 Error With Your HP Printer

Printer Error 49 usually appears when you are attempting to print a document using a HP printer and then a communication failure error occurs between the computer and the printer. However, there are other probable causes for this message with an error 49 code to appear. There is a chance that it is related to the file that is being printed, or it could be due to a firmware problem. You must determine the cause of the problem and then fix the error to be able to make use of your printer again. This tutorial will guide you how to resolve printer error 49 on HP printers.
HP printer error 49 is typically caused by invalid print commands, damaged or corrupted data, invalid operations or sometimes registry issues. Some problems that can be easily fixed are caused by poor quality of the parallel cables that connect the printer to the computer. To stop the error messages from appearing, you must make sure that all possible causes are ruled out.
The way to fix HP printer error 49 is to first calibrate the printer. You can calibrate your printer by performing all these steps:

• Clear the print job from memory by pressing the Cancel Job command.
• Restart the printer by turning it off and on again.
• Print another job and this time from a different program.
• If the job printing was successful, return to the first application and print another file.
• If the error message shows up only with a specific software program or print job, contact the software vendor to get assistance from them.
• If the error message persists even with a different software application and print job, take off all the cables that connect the printer to the PC or the network and then turn off the printer.
• Open the printer and remove the entire set of memory DIMMS or third party DIMMS, but, DO NOT remove the firmware DIMM inserted in slot J1.
• Also, remove all the EIO devices from the computer.
• Turn on the printer again.
• If the error message does not appear again, then one by one return each of the DIMMS and EIO devices and turn the printer on and off each time you install a device.
• If you have pinpointed a specific device, replace it.
• Reconnect all the cables to hook the printer back up again to the computer or network.
• If the error code 49 still persists, replace the DIMM firmware.
• Lastly, replace the formatter of the printer and then calibrate the printer again.

After calibrating your HP printer, you have to make sure that your Windows registry is free from errors. The registry is an important component of Windows that stores all file and program settings that allow your operating system remember to load and use the different programs on your PC. Despite its significance in your system, it can be affected by the constant use it inevitably undergoes. You need to resolve registry issues by using a reliable registry cleaner that can thoroughly clean your registry. We highly recommend that you make use of "Frontline Registry Cleaner", which can resolve 99% of system faults found in your system, allowing you to use your computer in its optimal condition.

Article Source: http://EzineArticles.com/5641707

Posted in: Printer Error,printer support